ZyXEL Communications 3.1 ユーザーズマニュアル

 Chapter 6 Interfaces

ZyWALL (ZLD) CLI Reference Guide

The following commands show you how to set the WAN1 interface to use a TCP handshake on port 
8080 to check the connection to IP address 1.1.1.2 

This section covers commands that are specific to Ethernet interfaces.

The following table identifies the values required for many of these commands. Other input values 
are discussed with the corresponding commands.

This table lists the commands you can use to set the MAC address of an interface. On the ZyWALL 
USG 200 and below models, these commands only apply to a WAN or OPT interface.

Router# configure terminal

Router(config)# interface wan1

Router(config-if-wan1)# ping-check 1.1.1.2 method tcp port 8080

Router(config-if-wan1)# exit

Router(config)# show ping-check

Interface: wan1

Check Method: tcp

IP Address: 1.1.1.2

Period: 30

Timeout: 5

Fail Tolerance: 5

Activate: yes

Port: 8080

Router(config)#

Input Values for Ethernet Interface Commands

The name of the Ethernet interface. This depends on the ZyWALL model. 

For the ZyWALL USG 300 and above, use gex, x = 1~N, where N equals the highest 
numbered Ethernet interface for your ZyWALL model.

The ZyWALL USG 200 and below models use a name such as wan1, wan2, opt, lan1, 
ext-wlan, or dmz.

interface Commands: MAC Setting

interface interface_name

Enters sub-command mode.

no mac

Has the interface use its default MAC address.

mac mac

Specifies the MAC address the interface is to use.