Canon VB101 ユーザーズマニュアル

Setup Procedures

"Main Camera"
Specifies the camera selected when the 
VB101 starts up.
 
"Baud rate of camera control port  CC1/CC2"
For CC1 and CC2, select the same baud 
rate as that set on the camera.
On the VC-C4/VC-C4R, the default setting 
is 9600.There is basically no need to 
change this.

"Return to Home Position when nobody has a 
control privilege"
The camera is moved to its home position 
if there is no request for a control 
privilege. (

→ P.44)

Settings for cameras 1 to 4
The camera1 to 4 correspond to cameras 
which are connected to V1 to V4.

"Use this Camera"
When you tick this option, this camera is 
used and the settings below are enabled.

"Camera Name"
Used in the camera selection bar in the 
WebView Livescope Viewer.
 
"Wide Converter"
Always select "Used" when a wide-angle 
converter is mounted on the camera.
 
"Video Signal"
Select Auto Detect, NTSC or PAL.
 
"Video Capture Size"
The available settings are 640x240, 
320x240 and 160x120.
 
"Video Quality"
Enter an integer between 1 and 99. The 
greater the value, the better the quality. 
However, since picture data will also be 
larger, higher-quality pictures may lower 
the frame rate.

Use this page to set the camera control parameters and the video capture size and quality.

→ P.