ONKYO DR-UN7 ユーザーズマニュアル
55
Naming Preset Channels
—Continued
If the unit is not in “Name In” mode, execute steps 1 and
2 in “Entering a Name,” then follow the steps below.
2 in “Entering a Name,” then follow the steps below.
1
Press TUNING
/
repeatedly until the
character following the desired point of
insertion flashes.
insertion flashes.
2
Turn MULTI JOG until “
” appears, then
press MULTI JOG.
3
Enter the desired character (or title) as per
Steps 3 and 4 in “Entering a Name”.
Steps 3 and 4 in “Entering a Name”.
To continue entering characters, follow Step 3 in “Enter-
ing a Name” on the previous page. To complete the oper-
ation, follow Step 5.
ing a Name” on the previous page. To complete the oper-
ation, follow Step 5.
1
Select AM or FM as the source.
2
Turn MULTI JOG to select the preset channel
name you wish to erase.
name you wish to erase.
3
Press EDIT/NO/CLEAR and turn MULTI JOG
until “Name Erase?” appears in the display.
until “Name Erase?” appears in the display.
4
Press YES/MODE.
“Complete” appears and the name is erased.
Inserting a Character
Erasing the Name Assigned to a
Preset Channel
Preset Channel
Inputting Characters from the
Remote Controller
Remote Controller
2, 3
3
1, 4
3
1
Press NAME.
2
Press DISPLAY repeatedly until
the character type you wish to
enter appears in the display.
the character type you wish to
enter appears in the display.
Each press of the DISPLAY switches
the type of characters.
the type of characters.
•
Inputting alphabetical characters:
Each press of a number button
cycles through a few characters of
the alphabets. For example, repeat-
edly pressing the 2ABC button dis-
plays A
cycles through a few characters of
the alphabets. For example, repeat-
edly pressing the 2ABC button dis-
plays A
→B→C→A in this order.
Display the desired character, then
press ENTER.
press ENTER.
•
Inputting numbers and symbols:
Pressing a number button displays
the corresponding number. Each
press of the >10 button or the 10/0
(
the corresponding number. Each
press of the >10 button or the 10/0
(
) button switches between the
symbols labeled on the correspond-
ing button. You can input “
ing button. You can input “
→ .
→ / → * → - →, → ! → ? → & →
’
’
→ ( → ) ” using the >10 button,
and
(space) using the 10/0 but-
ton. Display the desired number or
symbol, then press ENTER.
symbol, then press ENTER.
Note:
You cannot input all symbols from the
remote controller’s number buttons. To
input symbols, use the remote control-
ler’s PRESET
You cannot input all symbols from the
remote controller’s number buttons. To
input symbols, use the remote control-
ler’s PRESET
or
to select
the desired symbols.
3
Press NAME to complete the
naming process.
naming process.