ONKYO DR-UN7 ユーザーズマニュアル

61

By using the following audio adjust function, you can 
fine adjust the tone and the precise settings for Mono, 
Multiplex and T-D.

The Audio Adjust functions are explained below.

■

You can boost or cut low-frequency sounds output by the 
front speakers from –10 dB to +10 dB in 2 dB steps.
You can set a value when the listening mode is set to 
other than “Direct”.

■

You can boost or cut high-frequency sounds output by 
the front speakers from –10 dB to +10 dB in 2 dB steps.
You can set a value when the listening mode is set to 
other than “Direct”.

■

This setting specifies the channel to be used for playing 
any 2-channel digital source such as Dolby Digital, or 2-
channel analog/PCM source in the Mono listening mode.

LR: Both the left and right channels are output 

(default).

L: Only the left channel is output.

R: Only the right channel is output.

■

This setting determines which channel is output from a 
stereo multiplex source. Use it to select audio channels 
or languages with multiplex sources, multilingual TV 
broadcasts, and so on.

M: The main channel is output (default).

S: The sub channel is output.

MS: Both the main and sub channels are output.

■

Select this to modify the Theater-Dimensional (T-D) lis-
tening modes.
The listening angle is the angle subtended by the front 
left and right speakers as seen from the listener. The pro-
cessing for the virtual surround will be based on this 
angle. The setting of 20, 30 and 40 degrees are only for 
nominal purposes, so select the setting that is closest to 
your actual listening angle.

■

This is a setting for 5ch speaker composition with “T-D” 
(Theater-Dimensional) selected.
ALL: Select this setting when you use surround speak-
ers but they can not be placed in the right place.
FRT: Select this setting in other cases than above.
You can take advantage of the feature in the case where 
you have to place the surround speakers in front because 
of the restricted space availability or for other reason.

The display will show “1.Sp Config”.

And then press ENTER.

Select an item you want to configure 
using 

/

, and select a value or a 

preference using 

/

.

That exits the setting.
To return to a higher step, press 
RETURN.