Wayne-Dalton 9800 ユーザーズマニュアル
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section
online at www.Wayne-Dalton.com
34
Tools Needed:
DoorMaster
TM
Bracket
NOTE: When installing a DoorMaster
TM
operator use the center bracket and
drive gear supplied with your operator
(located in DoorMaster
drive gear supplied with your operator
(located in DoorMaster
TM
package).
slide the DoorMaster
TM
bracket/drive
gear assembly onto the TorqueMaster
®
spring tube, so that the drive gear/
center bracket assembly are in the
center of the TorqueMaster
center bracket assembly are in the
center of the TorqueMaster
®
spring
tube.
NOTE: after completing this step,
continue with step 17 on page 23.
continue with step 17 on page 23.
CENTER
BRaCkET
BusHING
assEMBly
TORquEMasTER
®
TuBE
A
A
DOORMasTER
TM
BRaCkET/
DRIVE GEaR assEMBly
locate the center bracket, mark the
header halfway between the flagangles
and level the TorqueMaster
header halfway between the flagangles
and level the TorqueMaster
®
spring
tube. Drill 1/8” pilot holes for the lag
screws. Fasten the metal bracket to
the header using (2) 1/4” x 1-1/2” lag
screws.
screws. Fasten the metal bracket to
the header using (2) 1/4” x 1-1/2” lag
screws.
NOTE: after completing this step,
continue with step 26 on page 29.
continue with step 26 on page 29.
B
B
Tools Needed:
Power Drill
1/8” Drill Bit
7/16” socket
Driver
DOORMasTER
TM
BRaCkET/
DRIVE GEaR assEMBly
TORquEMasTER
®
TuBE
(2) 1/4” x 1-1/2”
laG sCREWs