Husqvarna 575XP ユーザーズマニュアル

36 – English

Centrifugal cleaning means the following: All air to the 
carburetor passes through the starter. Dirt and dust is 
pushed out by the cooling fan.

IMPORTANT! In order to maintain operation of the 
centrifugal cleaning system it must be regularly maintained. 
Clean the air intake to the starter, the fins on the flywheel, the 
space around the flywheel, inlet pipe and carburetor 
compartment.

Running problems can occur when using the machine in the 
cold and snowy conditions caused by:

•

Too low engine temperature.

•

Icing of the air filter and carburetor.

Special measures are therefore often required:

•

Preheat the intake air to the carburetor by using the heat 
from the cylinder.

•

Partly mask the air inlet on the starter to increase the 
working temperature of the engine.

Cut out a hole using a knife as shown.

Fit the winter cover in the cylinder cover.

°°°°C (32°°°°F) or colder:

Move the cover from position A to position B so that 
preheated air from the cylinder can pass into the carburettor 
compartment and prevent, e.g. the air filter icing up again. 
When fitting the winter cover in position B the centrifugal 
cleaning nozzle is blocked. This measure requires the air 
filter to be cleaned more regularly.

°°°°C (23°°°°F) or colder:

For running the machine in cold weather or powder snow, a 
special cover is available, which is mounted on the starter 
housing. This reduces the intake of cold air and prevents 
large amounts of snow from being sucked in.

CAUTION! If the special winterising kit has been fitted or any 
measures have been taken to increase the temperature 
these changes must be reversed before the machine is used 
in normal temperature conditions. Otherwise there is a risk 
of overheating, resulting in severe damage to the engine.

IMPORTANT! Any maintenance other than that described in 
this manual must be carried out by your servicing dealer 
(retailer).

B

A

C