Husqvarna 966451906 ユーザーズマニュアル
English -
7
2 Introduction and safety instructions
Introduction and safety instructions
2.1 General
This Workshop Manual describes in detail how
to be troubleshoot, repair and test the chain saw.
A description of different safety steps that must be
taken during repair work is also given.
2.2 Safety
Note: The section dealing with safety must be
read and understood by all those carrying out
repair work or service on the chain saw.
read and understood by all those carrying out
repair work or service on the chain saw.
Warning symbols can be found in this Workshop
Manual and on the chain saw. See “Symbols on
the saw” and “Symbols in the Workshop Manual”.
A new warning symbol decal must be applied as
soon as possible if a warning symbol on the chain
saw has been damaged or is missing so that the
greatest level of safety can be maintained when
using the chain saw.
2.3 Target group
This Workshop Manual is written for personnel who
are assumed to have general knowledge of repair-
ing and servicing chain saws.
The Workshop Manual must be read and under-
stood by personnel who will carry out repair work
and service on the chain saw. The Manual is also
suitable for use when training new employees.
2.4 Modifications
Any modifications to the chain saw will be gradually
introduced into ongoing production. As these modi-
fications affect service and/or spare parts, specific
service information will be sent out on each occa-
sion. This means that in time this Workshop Manu-
al will become out of date. In order to prevent this,
the Manual should be read together with all service
information concerning the chain saw in question.
2.5 Tools
Special tools are required for some stages. All
service tools are listed in the Workshop Manual.
Usage is made apparent in each section.
Always use Husqvarna’s original:
• Spare parts
• Spare parts
• Service tools
• Accessories
2.6 Structure
This Workshop Manual can be used in two different
ways:
• Repair of a specific system on the chain saw.
• Dismantling and assembly of the entire chain saw.
• Dismantling and assembly of the entire chain saw.
Repair of a specific system
When a particular system on the chain saw is to be
repaired, proceed as follows:
1. Look up the page for the system in question.
2. Carry out the following steps:
2. Carry out the following steps:
Dismantling
Cleaning and inspection
Assembly
Assembly
Dismantling and assembling the chain saw.
Proceed as follows when the chain saw is to be
dismantled and assembled:
1. Open the “Repair instructions” chapter which
deals with the
Starter
and carry out the in-
structions outlined under the
Dismantling
heading.
2. Work forward in the Manual and carry out
Dis-
mantling
in the order set out in the sections.
3. Go back to the
Starter
and carry out the in-
structions under
Cleaning and Inspection
.
4. Work forward in the Manual and carry out
Cleaning and Inspection
in the order set out
in the sections.
5. Order or collect all requisite spare parts from
the stores.
6. Look up the “Repair instructions” chapter which
deals with the
Crankcase
and carry out the
instructions outlined in
Assembling
.
7. Work back in the Manual and carry out
Assem-
bling
in the order set out in the sections.
Some sections include an introductory
Descrip-
tion
of the actual unit in order to increase the basic
understanding.
2.7 Numbering
Position references to components inside the fig-
ures are designated A, B, etc.
The figures are numbered 1, 2 etc.
The position references and figure numbers restart