Husqvarna 365 EPA I ユーザーズマニュアル

English

 – 35

The air filter must be regularly cleaned to remove dust and dirt 
in order to avoid:

•

Carburettor malfunctions

•

Starting problems

•

Loss of engine power

•

Unnecessary wear to engine parts

•

Excessive fuel consumption.

•

Remove the air filter after taking off the air filter cover. 
When refitting make sure that the air filter seals tightly 
against the filter holder. Clean the filter by brushing or 
shaking it.

The filter can be cleaned more thoroughly by washing it in 
water and detergent.

An air filter that has been in use for a long time cannot be 
cleaned completely. The filter must therefore be replaced with 
a new one at regular intervals. A damaged air filter must 
always be replaced.

A HUSQVARNA chain saw can be equipped with different 
types of air filters according to working conditions, weather, 
season, etc. Contact your dealer for advice.

The spark plug condition is influenced by:

•

Incorrect carburetor adjustment.

•

An incorrect fuel mixture (too much or incorrect type of 
oil).

•

A dirty air filter.

These factors cause deposits on the spark plug electrodes, 
which may result in operating problems and starting 
difficulties.

If the machine is low on power, difficult to start or runs poorly 
at idle speed: always check the spark plug first before taking 
any further action. If the spark plug is dirty, clean it and check 
that the electrode gap is 0.020 inch (0.5 mm). The spark plug 
should be replaced after about a month in operation or earlier 
if necessary.

Note! Always use the recommended spark plug type! Use of 
the wrong spark plug can damage the piston/cylinder. Check 
that the spark plug is fitted with a suppressor.

Lubricate the bar tip sprocket each time you refuel. Use the 
special grease gun and a good quality bearing grease.

The clutch drum has a needle bearing on the output shaft. 
This needle bearing must be lubricated regularly (once a 
week). CAUTION! Use only high quality bearing grease or 
engine oil. See instructions under the heading Cutting 
equipment.

The oil pump is adjustable. Adjustments are made by turning 
the screw using a screwdriver or combination spanner. The 
machine is supplied from the factory set to 1 turn open. 
Turning the screw clockwise will reduce the oil flow and 
turning the screw anti-clockwise will increase the oil flow.

Recommended settings:

These recommendations apply to Husqvarna’s chain oil, for 
other chain oils increase the oil flow by one step.

Bar -15":

1 turn from the closed position.

Bar 15" -18":

2 turns from the closed position.

Bar 18" -24":

3 turns from the closed position.

Bar 24" -:

4 turns from the closed position.