Multiquip ONE-WAY PLATE COMPACTOR ユーザーズマニュアル
l
PAGE 16 — MVC77 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #4 (1/14/11)
2. The V-belt tension is proper if the V-belt bends 10 to 15 mm
(Figure 8) when depressed with finger at midway between
the clutch and vibration pulley shafts.
the clutch and vibration pulley shafts.
CLUTCH
PULLEY
VIBRATOR
PULLEY
V-Belt Check
Figure 6. V-Belt Hazard
1. To check the V-belt tension, remove the three bolts that
secure the belt cover to the frame as shown in Figure 7.
Figure 7. V-Belt Cover Removal
3. A loose V-belt will decrease the power transmission output,
causing reduced compaction and premature wear of the
belt.
belt.
4. If the V-belt becomes worn or loose, replace it by using V-
belt part number 070503350.
Figure 8. V-Belt Tension
INSPECTION
NEVER attempt to check the V-belt with the engine running.
Severe injury can occur of your hand (Figure 6) gets caught
between the V-belt and the clutch. Always use safety gloves.
Severe injury can occur of your hand (Figure 6) gets caught
between the V-belt and the clutch. Always use safety gloves.
CAUTION