Land Pride RCRM2510 ユーザーズマニュアル
21
Section 1: Assembly and Set-Up
5/09/08
RCR2596, RCR2510 and RCRM2510 Rotary Cutters 312-753M
Land Pride
2.
Remove parking jack (#1) from cutter deck and
secure to cutter tongue by fully inserting locking pin
(#2) through the parking jack and mounting bracket
as shown.
secure to cutter tongue by fully inserting locking pin
(#2) through the parking jack and mounting bracket
as shown.
3.
Add stroke control spacers to the cylinder rod to
prevent the cylinder from retracting. See “Pull-Type
Cutter” on page 23.
prevent the cylinder from retracting. See “Pull-Type
Cutter” on page 23.
4.
Use parking jack (#1) to raise and lower cutter
tongue to the correct height to disconnect clevis hitch
(#6) from the tractor drawbar.
tongue to the correct height to disconnect clevis hitch
(#6) from the tractor drawbar.
5.
Remove 1”-8 x 4 1/2” hex bolt (#3), flat washers (#5)
and locknut (#4) from the clevis hitch (#6).
and locknut (#4) from the clevis hitch (#6).
6.
Disconnect hydraulic hose (#9) from tractor. Store
hose end on cutter deck.
hose end on cutter deck.
Check Chains, 3-Point Lift-Type Cutters
(Available through Land Pride parts department.)
Refer to Figure 1-18:
Check chains are used to control the cutting height and
allow the mower to be lowered to the same preset cutting
height effortlessly.
allow the mower to be lowered to the same preset cutting
height effortlessly.
1.
Install lower end of check chain (#1) to the inner hitch
ear as shown in Figure 1-18, using the 3/4”-10 x 1 1/
2 long bolts (#2), lock washers (#3) and nuts (#4).
Tighten securely.
ear as shown in Figure 1-18, using the 3/4”-10 x 1 1/
2 long bolts (#2), lock washers (#3) and nuts (#4).
Tighten securely.
2.
Install chain lugs (#5) on either side of the tractor top
link mount using pin (not supplied).
link mount using pin (not supplied).
3.
Cutting height is then set by placing proper chain link
in key slot (#5).
in key slot (#5).
NOTE: For additional safety in transport, raise
cutter as high as possible, and shorten check chains
to prevent inadvertent falling in transport.
cutter as high as possible, and shorten check chains
to prevent inadvertent falling in transport.
Check Chain Assembly
Figure 1-18
22314