Makita EM4351UH ユーザーズマニュアル

P 13/ 22

(1) Remove Starter cover assembly by loosening 

      four M5x20 Hex socket head bolts.  (Fig. 52) 

(2) Pull Starter rope out of Starter cover assembly 

      approximately one winding long. 

      Then hook Starter rope on the U-shaped notch of 

      Reel, and then turn Reel clockwise until Spiral

      spring is unwound. (Fig. 53)

Note: Be careful with Reel because it will turn very 

           fast.

(3) Remove Reel from Starter cover by loosening 

      5x10 Tapping screw.

Note: Be careful with Spiral spring that can suddenly 

          pop out of Starter cover.

(4) Unite the knot of Starter rope to remove the rope 

      from Reel. 

DISASSEMBLING

ASSEMBLING

M5x20 Hex socket 

head bolt 

(4 pcs.)

Starter cover assembly

Reverse side of 

Starter cover assembly

Reel viewed from Starter cover side

Spring hook

of Reel

U-shaped 

notch of Reel

Starter rope

Starter rope

(1) If Spiral spring has popped out of Reel, put it back in place; hook the outer end of Spiral spring onto the spring hook

      of Reel first, then by winding Spiral spring counterclockwise towards the center of Reel. (Fig. 54)

(2) Apply a little amount of Makita grease N No.2 to the whole surface of Spiral spring.

(3) Put a new Starter rope through Starter cover.

      Then tie one end to Starter knob and the other to Reel by making 

      a knot. (Fig. 55)

(4) Make sure that the inner end of Spiral spring is positioned close to

      the shaft portion of Starter cover for the step (6). Then put Reel in 

      Starter cover.

(5) Wind Starter rope around Reel two or three times.

(6) While turning Reel counterclockwise, mount it in Starter cover.

      The inner end of Spiral spring will be engaged with the spring hook

      of Shaft portion in Starter cover by the counterclockwise rotation of 

      Reel. (Figs. 54 and 55)

      Note: You do not need force to mount Reel in place.

(7) Fasten Reel to the shaft portion of Starter cover with

      M6x20 Set screw. (Fig. 56)

      Note: Reel is not properly set in place if the rotation of 

Reel is slow after the screw is fastened. 

In this case, repeat steps (5) and (6) until normal

rotation of Reel is obtained.

(7) Hook Starter rope on the U-shaped notch of Reel.

      Then, while pulling Starter rope, turn Reel counter-

      clockwise. (Fig. 57)

      Release Starter rope from the U-shaped notch and 

      Starter rope will be wound around Reel due to the 

      rotational force of Spiral spring.  Repeat this operation

      until the slack is completely removed from Starter rope.

about 

10mm

about 

10mm

Starter rope

Starter rope

Reel

Spring hook of Shaft portion

in Starter cover

Inner end of

Spiral spring

Outer end of

Spiral spring

Reel

M6x20 Set screw

Starter cover

U-shaped notch of Reel