Makita EM4351UH ユーザーズマニュアル

P  3/ 22

(1) Press down the tab of Cleaner plate assembly gently and separate Cleaner cover assembly from Cleaner plate assembly 

      by loosening M5x20 Hex socket head bolt. (Fig. 1) 

(2) Loosen 5x16 Tapping screw and loosen Clamp that holds Bullet terminals near Cleaner plate assembly. (Fig. 2)

(3) Disconnect Bullet terminals of Earth wire and Primary wire of Ignition coil from the wires of Stop switch. (Fig. 2)  

(4) Remove Control cable from Swivel of Carburetor; loosen the three nuts on Control cable to release the tension 

      between Swivel and Cable bracket of Insulator, then remove the stopper on Inner cable end from Swivel. (Fig. 3)

(5) For EM4351UH: Remove M5x8 Hex socket head bolt and M6x30 Hex socket head bolt in the holes of Pipe housing.

      (Fig. 4) 

      For EM4350UH and EM4350LH: Remove M5x8 Hex socket head bolt and M6x30 Hex socket head bolt from 

the threaded holes of Clutch case. (Fig. 5)

(6) Grab Shaft pipe complete by hand, then pull it off from Clutch case. 

      If Shaft sticks in Clutch case, use water pump pliers or the like to pull it off.

Note:  Be sure to wrap Shaft with a rag or the like to protect it from water pump pliers. (Fig. 6)

Clamp

Cleaner plate assembly

Swivel of Carburetor

Inner cable

5x16

Tapping

screw

M5x8 

Hex socket

head bolt

M5x8 Hex socket

head bolt

M6x20

Hex socket

head bolt

M6x20 Hex 

socket head bolt

Holes of 

Pipe housing

Threaded holes 

of Clutch case

M5x20 Hex socket

head bolt

Control cable

Tab of

Cleaner plate assembly

Cleaner cover

assembly

Bullet terminals

Cable bracket of Insulator 

Stopper on Inner cable end

Nut on Control cable end

(3 pcs.)

Swivel of Carburetor

Shaft

Rag

Water pump

pliers

Shaft pipe complete