Makita EK7651H ユーザーズマニュアル

Description

Code No.

Use for

Retaining ring pliers ST-2N for External ring

1R003

press-fitting Ball bearing 6203LLU into Cutting device

Bearing setting pipe 25-17.2

1R030

assembling Clutch complete to Crankshaft

Torque wrench shaft 20-90N·m

1R223

Follow the instructions described below in advance before repairing:

 • Wear gloves.

 • Remove the cutting tool from the unit.

 • When the engine is hot from use, cool down the engine enough or you can get burned.

 • Remove remaining fuel from Fuel tank and Carburetor completely. 

 • Remove Spark plug cap from Spark plug.

 • Repair the engine on a stable workbench and in a clean workplace kept as free of dust and debris as possible.

 • In order to avoid wrong reassembly, draw or write down where and how the parts are assembled, and what are the parts.

    It is also recommended to have boxes ready to keep disassembled parts by group.

 • Handle the disassembled parts carefully. Clean and wash them properly.

 • If some bolts and screws are too tight, use Impact driver.

 • Tighten the bolts and the screws to the specified torque as shown in "[5] Tightening torque specifications".

 • Each time after you mounted a main part of the engine such as the piston, check if it moves smoothly 

    without abnormal noise by manually turning the crankshaft.

 • After completion of reassembly, check for loose parts or abnormal noise and vibration

    by manually turning the crankshaft.

removing Lock off lever

Ratchet head 12.7 (for 1R223)

1R224

removing/ assembling Cotter

Screwdriver magnetizer

1R288

Retaining ring pliers RT-2N for Internal ring

1R005

removing Cotter

removing Pin 5 from Rocker arm assembly

Spring pin extractor 4.0

1R308

Hexalobular bit VT-27 (6.35mm)

1R290
1R291

removing/ assembling Hexalobular bolt

Retaining ring pliers

1R311

removing Tubes

Flywheel puller

1R364

removing Flywheel

Feeler gauge set

1R366

adjusting the gap between Ignition coil and Flywheel, 

Rocker arm assembly and Valve section, Spark plug

Crank shaft lock bolt M10

holding the position of Piston/ preventing Crankshaft from 

being rotated

1R372

Cotter removal attachment

1R389

removing Exhaust / Intake valve system

Retaining ring S and R pliers

removing/ installing Retaining ring R-40

Socket/ Socket bit 17

---

removing/ installing Clutch

Socket/ Socket bit 24

---

removing/ installing Clutch

Wire brush

---

cleaning Spark plug

Hex wrench 2.5

---

assembling/ removing / adjusting M5 Hex socket head bolt

Wrench 8

---

holding M5x9 Hex nut

P  2/ 19

Once Gasket is removed:

(1) Clean up the mating surface where the gasket was installed to maintain its sealing performance.

(2) Replace it with a new one.