Makita DBC4510 ユーザーズマニュアル
12
G
-
Press the locking button (G/9) and hold it down, while using
the combination wrench to turn the shaft counter-clockwise
until the locking button engages and locks the shaft.
the combination wrench to turn the shaft counter-clockwise
until the locking button engages and locks the shaft.
-
Now tighten the locknut counter-clockwise using the
combination wrench (25-30 Nm).
combination wrench (25-30 Nm).
-
To unlock the locked shaft press the release button
(G/10). The locking button (G/9) will trip (if necessary turn
the cutting tool slightly).
(G/10). The locking button (G/9) will trip (if necessary turn
the cutting tool slightly).
-
Check to make sure the cutting tool can turn freely.
Use the shaft lock in the same way when dismounting the cut-
ting tool.
ting tool.
10
9
Installing the trimmer head
Always switch off the engine and
disconnect the spark plug cap
before mounting the trimmer head!
disconnect the spark plug cap
before mounting the trimmer head!
H
When using the trimmer head install the cutter guard with the
mounting plate in position A (see “Installing the cutter guard”).
Always install the line cutter (see below, “Installing the line
cutter”)!
mounting plate in position A (see “Installing the cutter guard”).
Always install the line cutter (see below, “Installing the line
cutter”)!
-
Unscrew the locknut (H/1) from the shaft by turning it
clockwise.
clockwise.
Note: The locknut has a left-hand thread!
-
Place the pressure disk (H/4) on the shaft as shown.
1
4
5
6
-
If necessary, install the winding guard (H/6) (three screws).
To do so, first remove the locking disk (H/5) (note its position
as installed).
To do so, first remove the locking disk (H/5) (note its position
as installed).
-
Screw the trimmer head onto the shaft by turning it
counter-clockwise.
counter-clockwise.
-
Press the locking button (I/9) and hold it down while turning
the trimmer head counter-clockwise until the locking button
engages, locking the shaft.
the trimmer head counter-clockwise until the locking button
engages, locking the shaft.
-
Now tighten the trimmer head by hand.
-
Press the release button (I/10) to unlock the shaft. The
locking button (I/9) will jump out (it may be necessary to
turn the trimmer head slightly).
locking button (I/9) will jump out (it may be necessary to
turn the trimmer head slightly).
-
Check to make sure the trimmer head can turn freely.
I
2-line trimmer
head shown
head shown
9
10
J
The line cutter and its mounting screw are included in the
accessory pack.
accessory pack.
-
The picture shows the line cutter (J/11) mounted on the
cutter guard with the mounting screw.
cutter guard with the mounting screw.
Note:
If you adjust the length of the trimmer line (see page 19),
the line cutter will automatically cut the lines to identical
length during operation.
the line cutter will automatically cut the lines to identical
length during operation.
Caution:
Always turn off the engine before adjusting the line
length!
length!
11
Installing the line cutter
STOP
STOP