Makita DBC4510 ユーザーズマニュアル

16

-

Move the switch (G/6) in the direction of the arrow.

-

To set the half-throttle catch, press the throttle (G/8) with
the throttle trigger lockout (G/7) pressed and then press
the catch (G/10). Release the throttle (G/8) and then the
throttle trigger lockout (G/7).

H

-

Turn the choke lever (H/9) downwards to  choke the engine.

I

-

Hold the brushcutter frimly down with one hand, as
illustrated above.

-

Pull the starter handle out slowly until resistance is noticed,
then pull the starter handle out fully with a quick and forceful
movement.

-

Do not pull out the whole starter cable to its full extent and
do not let the starter handle jump back, but let it slowly
automatically rewind itself.

-

Repeat starting procedure until ignition is achieved.

-

Turn the choke lever (H/9) back up and pull the starter
cable again until the engine starts.

-

After the engine has started, press the throttle (J/8) all the
way in and release immediately. This will disengage the
half-throttle position.

-

Run the engine for approximately 1 minute at a moderate
speed before commencing work.

Similar to a cold start but without the choke.

Move switch (J/6) to the position            .

-

Move at least 10 feet (3 meters) away from where you filled
the fuel tank.

-

Make sure you have a good footing, and lay the brushcutter
on the ground in such a way that the cutting tool is not
touching the ground or anything else.

G

J