Land Pride RCM4015 ユーザーズマニュアル

10/21/15

Cutter wings will need to be raised before transporting on a 
roadway, through narrow gate openings and when 
servicing the deck underside.

1.

Disengage tractor PTO and wait for cutter blades to 
come to a complete stop before raising wings.

2.

Rotate cutter wings fully up with hydraulics.

3.

Place tractor gear selector in park, shut tractor 
engine off or set park brake, remove switch key, and 
dismount from tractor.

4.

See Figure 3-3: Remove hairpin clip (#1) from 
storage lug (#2).

5.

See Figure 3-4: Rotate end of transport lock bar (#3) 
to cylinder pin (#4). Secure with hairpin clip (#1). 

6.

Repeat steps 4 and 5 for the other wing. Your cutter is 
now ready for transporting.

IMPORTANT: Always disengage tractor’s PTO & 
wait for blades to come to a complete stop before 
raising cutter wings to transport position. Wing 
drivelines, wing gearboxes, and splitter gearbox can 
be damaged if driveline is turning.

NOTE:  The wings are controlled with two hydraulic 
lift cylinders. Be certain that the wing hydraulics are 
attached to the tractor and the hydraulic hoses are 
full of oil before proceeding.

27923

3

2

1

4

1.

Select a safe ground speed when transporting from 
one area to another. Maximum transport speed for 
the Rotary Cutter is 20 mph. DO NOT EXCEED.

2.

Be sure to reduce tractor ground speed when turning 
and leave enough clearance so the cutter does not 
contact obstacles such as buildings, trees, or fences.

3.

Always raise wings and set transport locks before 
traveling on public roadways. 

4.

When traveling on roadways, transport in such a way 
that faster moving vehicles may pass you safely.

5.

Shift tractor to a lower gear when traveling over rough 
or hilly terrain.

1

4

3

27921

IMPORTANT: Make slow tight turns to the right and 
left to determine if and at what angle the rear tractor 
tires may come in contact with the deck and/or hitch.