Land Pride RCF2760 and RCF2772 ユーザーズマニュアル

12/15/15

Type of Lubrication: Grease

Quantity = 6 pumps

Type of Lubrication: Multi-purpose Grease

Quantity = 2 pumps

Method 1: Unscrew top vented dipstick (#1). Wipe oil 
from dipstick and screw dipstick in without tightening. 
Unscrew dipstick and check oil on dipstick. If below 
bottom level mark, add recommended gear lube through 
dipstick hole until oil reaches top mark on dipstick. 
Reinstall vented dipstick and tighten.

Method 2: Remove side oil plug (#2). If oil is below 
bottom of plug hole, add recommended gear lube 
through top dipstick hole until oil flows out of side plug 
hole. Reinstall and tighten side oil plug (#2) and vented 
dipstick (#1).

Type of Lubrication: 80-90W EP Gear Lube 

Quantity = Fill until oil reaches top mark on dipstick or 
begins to flow out side plug hole in gearbox.

NOTE:  Do not overfill! Cutter should be level when 
checking oil. Oil expands when hot, therefore, always 
check oil level when cold.

30578

30578

30215

IMPORTANT: Your cutter is shipped with a vented 
dipstick packaged in the Operator’s Manual bag and 
should have been installed in the gearbox by your 
Land Pride dealer. Please see your Land Pride dealer 
if vented dipstick was not included.

NOTE:  Use a suction or siphon pump to drain 
gearboxes of oil when there is not an oil drain plug.

Multi-purpose 
spray lube

Multi-purpose 
grease lube

Multi-purpose 
oil lube

Intervals in hours at which
lubrication is required