Cub Cadet cs3310 ユーザーズマニュアル

3. 

Remove the hairpin clip from the clevis pin which extends 

through the housing and shredder screen. See Figure 6-1B. 

Remove clevis pin.

4. 

Pivot the shredder screen upward. See Figure 6-1C. Clean 

the surrounding area by scraping away debris.

5. 

Confirm that the spark plug wire is disconnected and away 

from spark plug. Pull on the starter rope two-to-three 

times to purge any remaining debris from the reduction 

chamber.

6. 

When the area is cleaned, pivot the shredder screen 

downward and re-secure with the clevis pin and hairpin 

clip removed earlier.

7. 

Reattach the debris collection bag to the chute deflector, if 

desired.

The impeller’s shredder blade and 

chipper blades are sharp. Wear leather work gloves 

to protect your hands when cleaning out the 

reduction chamber.

If the reduction chamber becomes clogged with debris, the 

shredder screen can be pivoted upward so that you can clean the 

surrounding area. To do so, proceed as follows:
1. 

Stop engine, disconnect spark plug, and make certain the 

chipper shredder has come to a complete stop.

The muffler and surrounding area will 

be hot if the engine has been running. Use caution 

and protect your hands if working near the muffler. 

2. 

If attached, remove debris bag. Remove the two wing 

knobs on either side of the chute deflector and pivot the 

chute deflector upward. See Figure 6-1.

A

C

B