JVC VN-X35U ユーザーズマニュアル

64

● The area display position serves as a reference. Make sure to perform operation check.

● The screen is divided into blocks of 80 (10 horizontal x 8 vertical).

Set the angle of view such that the size of the object for which motion is to be detected is larger than 
the size of multiple blocks.

● Flickers of fluorescent lamps may cause  motion detection.

● Changes in brightness due to the light source may be detected as motion.

● Plugging/Unplugging the infrared ray filter in black-and-white mode may cause motion detection .

● The motion detection feature is not intended to prevent theft or fire. This feature may not function 

properly depending on the conditions of the object and settings.
Our company shall not be liable for any accident or damage that occurs.

● When images on VN-X35U are currently acquired by another client or Built-in Veiwer, video images 

may not appear on the [Motion Detection] page due to the maximum distribution limit of VN-X35U. 
Stop other clients or Built-in Veiwer before using the [Motion Detection] page.

A

The screen is divided into blocks of 10 (horizontal) x 8 (vertical). Use this to 
set whether to mask each block.
All blocks are masked in the default setting.
The block turns blue when it is clicked, indicating that it is unmasked. Click 
again to return to the masked state.
Press the [OK] button to enable this setting.
Use the [Mask All] button to mask all blocks.
Use the [Clear Mask] button to unmask all blocks.

B

For setting motion detection to On/Off.
Press the [OK] button to enable this setting.

● Even though motion detection is set to AOnB, the motion of masked 

blocks cannot be detected.

C

To apply the new parameters, press the [OK] button. Press the [Cancel] 
button to cancel the change.

D

For setting the sensitivity of motion detection.
Increasing the number raises the detection sensitivity level, and hence it is 
more sensitive.
Press the [OK] button to enable this setting.

E

Masks all blocks.
Press the [OK] button to enable this setting.

F

Unmasks all blocks and enables the current motion detection and detection 
sensitivity settings.
Press the [OK] button to enable this setting.