Brinly-Hardy PA-40 BH ユーザーズマニュアル

22

25

25

30

11

23 30

32

27

16

19

14

11

32

10

7a. Push the Axle Assembly (10) through the left

side plate as far as possible and rotate so the

hole in the flat plate faces to the rear as shown.

Install the Lift Handle Assembly (11) with the

welded tube facing out, to the Axle Assembly

(10). Secure with Hex Bolt (19) and Nylon Lock

Nut (32).

7b. Slip Handle Grip (14) over end of Lift Handle

Assembly (11). NOTE: Soapy water will ease

the assembly.

7a. Pre-assemble axle bolt. Install Flat Washer

(25) over Hex Bolt (22). Slide assembly through

wheel, note orientation. Place Flat Washer (25)

and Hex Nut (30) on Bolt and thread on as far as

possible, still allowing wheel to rotate freely.

7b. Install through holes in Lift Handle (11) and

Axle Assembly (10). Install Lock Washer (23)

and Hex Nut (30). Tighten inside Hex Nut while

holding Hex Nut next to wheel stationary.

7c. Insert Transport Pin (27) in rear hole same

side as Lift Handle Assembly (11) as shown.

Secure with Nylon Lock Nut (32).

Hex Head Bolt, 5/16" x 1-1/2"

Qty. 1

Transport Lock Pin

Qty. 1

Nylon Lock Nut, 5/16"

Qty. 1

Nylon Lock Nut, 5/16"

Qty. 1

Handle Grip

Qty. 1

(Not To Scale)

Flat Washer, 5/8"

Qty. 4

Lock Washer, 5/8"

Qty. 2

Hex Nut, 5/8"

Qty. 4

Hex Bolt, 5/8" x 4"

Qty. 2