Brinly-Hardy PA-48 BH ユーザーズマニュアル

5

10

12

15

13

12

26

26

26

26

9

15

13

28

15

20

24

Hex Head Bolt, 5/16" x 3/4"

Qty. 24 for PA-40 BH

Qty. 32 for PA-48 BH

Nylon Bearing, 3/4" I.D.

Qty. 6 for PA-40 BH

Qty. 8 for PA-48 BH

Lock Nut, 5/16"

Qty. 24 for PA-40 BH

Qty. 32 for PA-48 BH

5a. Assemble Plugging Spoons (9) to each

welded plate (side opposite welds) of all the Tube

Assemblies (12 and 13) as shown. For PA-48H,

pre-assemble Hex Bolts (20) and Flat Washers

(24). NOTE: PA-40BH does not use Flat Washers.

Install the Bolt (and Washer Assemblies) through

Plugging Spoons and secure with Lock Nuts (28).

Rounded part of spoon fits

against the tube to lock in place.

5b. Insert a Nylon Bearing (15) into each end of

the tube assemblies.

6a. The End Tube Assemblies (12) have one

plate approximately 1-1/8" from the end of the

tube. The Center Tube Assemblies (13) have

each plate approximately 2-3/4" from the end of

the tube.

6b. Place a Machinery Bushing (26) over Axle

Assembly (10). Insert Axle Assembly through

Right Side Plate and install in the following order:

End Tube Assembly (12) with short hub end

•

next to side plate.

Machinery Bushing (26).

•

Center Tube Assembly (13).

•

For PA-48 BH only:

Center Plate (33) and then another Center

•

Tube Assembly (13).

For all models:

Machinery Bushing (26).

•

End Tube Assembly (12) with short hub end

•

next to side plate.

One or more Machinery Bushings (26) as

•

required to eliminate any side play in axle

assembly.

One or more Machinery Bushings as required to

eliminate any side play in axle assembly.

Flat Washer, 5/16"

Qty. 32 used on

PA-48 BH ONLY!

Machinery Bushing, 3/4"

Qty. 6

Make sure Nylon Bearings

(15) are inside Tube

Assemblies (Installed in Step 5b)