Snapper RP217019BV ユーザーズマニュアル

 

 

2. Using needle nose pliers, unhook the drive 

spring and slide the driven disc assembly off the 

hex shaft. See Figure 4.12. 

3.  Remove the two snap rings which secure the 

rubber driven disc to the driven disc assembly.  See 

Figure 4.13. 

4.  Install new rubber driven disc onto driven disc 

assembly with retaining rings. 

5.  Reverse above procedures for reassembly and 

installation of driven disc assembly. 

 

 

 
 
 
 

 

 

 

 

 

 

 

 

 

 

 

 

IMPORTANT: The bearing on these machines is staked 

into the thrust plate. The bearing will have to be driven 

out with a mallet and a large punch. A new bearing with 

four retaining screws will have to be purchased to 

replace existing bearing. 

If the driven disc bearing requires replacement, 

remove the driven disc assembly and replace 

bearing as follows: 

1.  Remove pin and washer from transfer rod, and 

remove end of transfer rod from hole in driven disc 

assembly. See Figure 4.9. 

2. Using needle nose pliers, unhook the drive 

spring and slide the driven disc assembly off the 

hex shaft. See Figure 4.12. 

3.  Remove both snap rings that secure rubber 

driven disc hub to thrust plate. See Figure 4.13. 
4.  Slide the rubber driven disc hub out of the 
bearing. 
5.  Drive out existing bearing. 
6.  Install new bearing and secure to thrust plate 
with four retaining screws. Tighten screws securely. 
7.  Reassemble components in reverse order.