Snapper RP217019BV ユーザーズマニュアル

 

 

2.  Set all wheels at the same cutting height.  The 
highest cutting position is Notch 7. The lowest 
cutting position is Notch 1. See Figures 2.8 & 2.9. 

 

 

 

NOTE: For best recycling results, cut up to a maximum of 1/3 
of grass blade length and recycle ONLY when grass is dry. 

1.  Set all wheels in the highest cutting position (Notch 
7). Refer to Section “Cutting Height Adjustment”. 
2.  Move engine speed control to “FAST” (Rabbit) 
position. 
3. Move ground speed control to slowest speed 
setting. 
4. Proceed mowing slowly. If grass is very dense, 
lower each rear wheel latch one notch lower than the 
front wheel latches to improve recycling performance. 

 

TO RAISE RECYCLING COVER:  
Remove knob nut and internal/external tooth lock washer 
securing rear of recycling cover to mower deck.  Pull rear 
of cover out from stud, and flip cover forward. See Figure 
2.10. 

DO NOT attempt any maintenance, adjustments or 
service with engine and blade running. STOP 
engine and blade. Disconnect spark plug wire and 
secure away from spark plug. Engine and 
components are HOT. Avoid serious burns, allow 
sufficient time for all components to cool. 
 
2.7   INSTALLATION OF SIDE DISCHARGE 
DEFLECTOR 
STEP 1: Raise recycling cover. Refer to Section 
“Recycling Operation”.   
STEP 2: Install deflector to deck underneath raised 
recycling cover, making sure that: 1) outside front edge of 
deflector slips behind recycling cover hinge bracket, 2) 
slot on inside front of deflector slips under restraining nut 
on top of deck (under right front corner of engine), and 3) 
slot on inside rear of deflector slips onto stud behind rear 
of discharge opening, where rear of recycling cover was 
originally secured. See Figure 2.11. Install 
internal/external tooth lock washer and knob nut onto stud 
and tighten securely. Release recycling cover and allow 
it to rest against side discharge deflector. 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
2.8  INSTALLATION OF GRASS BAG ADAPTER 
(Optional Accessory on Some Models) 
STEP 1: Raise recycling cover. Refer to Section 
“Recycling Operation”.   
STEP 2: Install grass bag adapter to deck in place of 
raised recycling cover, making sure that: 1) outside front 
edge of adapter slips behind recycling cover hinge 
bracket, 2) slot on inside front of adapter slips under 
restraining nut on top of deck (under right front corner of 
engine), and 3) slot on bottom rear of adapter slips onto 
stud behind rear of discharge opening, where rear of 
recycling cover was originally secured. See Figure 2.12. 
Install internal/external tooth lock washer and knob nut 
onto stud and tighten securely. Release recycling cover 
and allow it to rest against adapter.