Woods Equipment MZ3761K-DFI ユーザーズマニュアル

35

  

 

 

The rear outside deck rollers are adjustable up and 

down to provide improved deck flotation and scalp-

ing protection at various heights of cut.  They are not 

intended to ride continuously on the ground.  Adjust 

no closer than 3/8" (10mm) to the ground.

The height of cut is set by moving height of cut pin 

C 

to the hole designated for the height of cut desired.  

To change the height of cut:
1.  Lift the deck to the highest position.

2.  Move pin 

C to the selected hole.  

3.  Lower the deck until the lift lever is stopped by 

the pin.

NOTES:  
–  Height of cut may vary due to the amount of 

tread on the tires, tire diameter or inflation pres-

sure. Rear wheels 12 p.s.i.

–  For best results, adjust the rear deck rollers for 

the height of cut to be used (see below).

Adjustable front deck lips have been provided on 52 

in. and 61 in. cutterdecks for various cutting condi-

tions. 

To revise per conditions:
1.  Loosen the front bolts S.

2.  Adjust height of H.  

3.  Retighten S once you have desired height.