Alamo 272 ユーザーズマニュアル
ASSEMBLY
260/272/284 01/11
Assembly Section 3-6
© 2011 Alamo Group Inc.
ASSEMBL
Y
TONGUE (Pull Type)
Insert tongue lugs (4) between mainframe uprights and retain using special pin (16). Insert retaining clip (17) to
retain pin. Be sure to install bushing (19) on each side to eliminate side movement. Figure Asm-R-0405
retain pin. Be sure to install bushing (19) on each side to eliminate side movement. Figure Asm-R-0405
AXLE ASSEMBLY
Attach rear axle (1) to the lugs on the rear of the mainframe using 3/4 x 3 (8) bolts, bushings (7), flatwashers
(4) and locknuts (6). Tighten all bolts. Attach level lift rod assemblies to axle (1) Figure Asm-R-0406 and
tongue (1) Figure Asm-R-0405 using clevis pin (15), flatwashers (31) and cotter pin (38). NOTE: The
adjusting nuts on control rods should be to rear of machine. Figure Asm-R-0406
(4) and locknuts (6). Tighten all bolts. Attach level lift rod assemblies to axle (1) Figure Asm-R-0406 and
tongue (1) Figure Asm-R-0405 using clevis pin (15), flatwashers (31) and cotter pin (38). NOTE: The
adjusting nuts on control rods should be to rear of machine. Figure Asm-R-0406