Poulan PB22H54BF ユーザーズマニュアル

INSTALL MOWER AND DRIVE BELT

(See Figs. 4-12)

See MOWER AND DRIVE BELT ASSEMBLY Supplement

Sheet for additional guidance on this assembly.
Be sure tractor is on level surface and engage park-

ing brake.
• Lower attachment lift lever to lowest position.

CAUTION: Lift lever is spring loaded.

Have a tight grip on lift lever, lower it

slowly and engage in lowest position.

• Turn steering wheel to the left as far as it will go

and position mower on right side of tractor with

deflector shield to the right.

•

Remove plastic tie securing belt, bring belt forward

and check belt for proper routing in all mower pul-

ley grooves.

02965

ASSEMBLE FRONT WHEEL TO

MOWER (See Fig. 3)

•

Using shoulder bolt, washer and locknut from parts

bag, as sem ble front wheel to mower as shown.

Tighten securely.

FIG. 3

FIG. 4

FIG. 2

NOTE: You may now roll or drive your tractor off the

skid. Follow the ap pro pri ate instruction below to remove

the tractor from the skid.

WARNING: Before start ing, read, un der stand and

fol low all in struc tions in the Op er a tion section of this

man u al. Be sure tractor is in a well-ventilated area. Be

sure the area in front of tractor is clear of other peo ple

and objects.

TO ROLL TRACTOR OFF SKID (See Op-

er a tion section for location and function of

con trols)

• Raise attachment lift lever to its highest po si tion.
•

Release parking brake by de press ing brake ped al.

• Place freewheel control in dis en gaged po si tion to

dis en gage trans mis sion (See “TO TRANS PORT”

in the Op er a tion section of this manual).

• Roll tractor forward off skid.

TO DRIVE TRAC TOR OFF SKID (See Op-

er a tion section for location and function of

con trols)

• Be sure all the above assembly steps have been

completed.

• Check engine oil level and fill fuel tank with gaso-

line.

•

Place freewheel control in "trans mis sion engaged"

position (see "TO TRANSPORT" in Operation sec-

tion of this manual).

• Sit on seat in operating position, depress brake

pedal and set the parking brake.

• Raise attachment lift lever to its highest position.
•

Remove key from bag and start the engine (see "TO

START" in the Operation section of this manual).

After engine has started, move throttle control to

idle (slow) position.

• Release parking brake.
•

Slowly depress forward drive pedal and drive trac-

tor off skid.

• Apply brake to stop tractor and set park ing

brake.

• Turn ignition key to "STOP" position.
Continue with the in struc tions that follow.

ADJUST SEAT (See Fig. 2)

• Sit in seat.
• Lift up adjustment lever (A) and slide seat until a

comfortable position is reached which allows you

to press clutch/brake pedal all the way down.

• Release lever to lock seat in position.

ASSEMBLY