Poulan PP21H42 ユーザーズマニュアル

If steering wheel crossbars are not horizontal (left to right) 

when wheels are positioned straight forward, remove steer-

 ing wheel and reassemble per instructions in the Assembly 

section of this manual.

The front wheel toe-in and camber are not adjustable on 

your tractor.  If damage has occurred to affect the front 

wheel toe-in or camber, contact your nearest authorized 

service center/department.

Should your transmission require removal for service or 

replacement, it should be purged after reinstallation and 

before operating the tractor.  See “PURGE TRANS MIS SION” 

in the Operation section of this manual.

•  Block up axle securely.
• 

Remove axle cover, retaining ring and washers to allow 

wheel removal (rear wheel contains a square key - Do 

not lose).

•  Repair tire and reassemble.
•  On rear wheels only:  align grooves in rear wheel hub 

and axle.  Insert square key.

•  Replace washers and snap retaining ring securely in 

axle groove.

•  Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to 

slow leaks, tire sealant may be purchased from your local 

parts dealer. Tire sealant also prevents tire dry rot and 

corrosion.

WARNING:  Lead-acid batteries gen-

If your battery is too weak to start the engine, it should be 

recharged. (See "BATTERY" in the Maintenance sec tion 

of this man u al).
If “jumper ca bles” are used for emer gen cy starting, follow 

this pro ce dure:

IMPORTANT:  YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT 

SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT 

SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START 

OTHER VEHICLES. 

TO ATTACH JUMPER CABLES -

•  Connect one end of the RED cable to the POSITIVE 

(+) terminal of each battery(A-B), taking care not to 

short against tractor chassis.

• 

Connect one end of the BLACK ca ble to the NEGA TIVE 

(-) terminal (C) of fully charged battery.

• 

Connect the other end of the BLACK cable (D) to good 

chassis ground,  away from fuel tank and bat tery.

TO REMOVE CABLES, REVERSE ORDER -

• 

BLACK cable first from chassis and then from the fully 

charged battery.

•  RED cable last from both batteries.

02614

• Raise 

hood.

•  Pull bulb holder out of the hole in the backside of the 

grill.

•  Replace bulb in holder and push bulb holder securely 

back into the hole in the backside of the grill.

• Close 

hood.

Loose or damaged wiring may cause your tractor to run 

poorly, stop running, or prevent it from starting.

• 

Check wiring. See electrical wiring diagram in the Repair 

Parts section.