Poulan CO18542STA ユーザーズマニュアル

24

TO REPLACE HEADLIGHT BULB
1.   Raise hood.
2.   Pull bulb holder out of the hole in the 

backside of the grill.

3.   Replace bulb in holder and push bulb 

holder securely back into the hole in 
the backside of the grill.

4.   Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause 
your tractor to run poorly, stop running, or 
prevent it from starting.
•   Check wiring.  See electrical wiring 

diagram in the Repair Parts section.

TO REPLACE FUSE
Replace with 20 amp automotive-type 
plug-in fuse.  The fuse holder is located 
behind the dash.

TO REMOVE HOOD AND GRILL AS-
SEMBLY 
1.   Raise hood.
2.   Unsnap headlight wire connector.
3.   Stand in front of tractor.  Grasp hood at 

sides, tilt toward engine and lift off of 
tractor.

4.   When replacing hood, be sure to re-

connect the headlight wire con nec tor.

02141

Headlight 
Wire 
Connector

Hood

TO AD JUST THROTTLE  CON TROL 
CABLE 
The throttle control has been preset at the 
factory and ad just ment should not be nec-
essary.  Check adjustment as described 
below before loosening cable.  If adjust-
ment is necessary, see engine manual

The carburetor has been preset at the 
factory and ad just ment should not be nec-
essary.  However, minor ad just ment may 
be required to compensate for dif fer enc es 
in fuel, temperature, altitude or load.  If 
the carburetor does need ad just ment, see 
engine manual.

0217

9

Keps Nut

Terminal 
Guard

Terminal 
Access 
Door

Hex Bolt

Positive 
(Red) 
Cable

Negative (Black) 
Cable

 WARNING:  Do not short battery 

ter mi nals by allowing a wrench or any 
other object to contact both terminals at 
the same time. Before connecting battery, 
remove metal bracelets, wristwatch bands, 
rings, etc.
Positive terminal must be connected 
fi rst to prevent sparking from ac ci den tal 
grounding.
1.   Lift hood to raised position.
2.   Remove terminal guard.
3.   Disconnect BLACK battery cable 

then RED battery cable and carefully 
remove battery from tractor.

4.   Install new battery with terminals in 

same position as old battery.

5.   Reinstall terminal guard.
6.   First connect RED battery cable to 

positive (+) battery terminal with hex 
bolt and keps nut as shown. Tighten 
securely.

7.   Connect BLACK grounding cable to 

negative (-) bat tery terminal with re-
 main ing hex bolt and keps nut. Tight en 
securely

8.    Close terminal access doors.
9.    Close hood.

02614

Weak or Dead
Battery

Fully Charged
Battery

2.   Connect one end of the BLACK ca ble 

to the NEGA TIVE (-) terminal (C) of 
fully charged battery.

3.   Connect the other end of the BLACK 

cable (D) to good chassis ground,  
away from fuel tank and bat tery.

TO REMOVE CABLES, REVERSE 
ORDER -
1.   BLACK cable fi rst from chassis and 

then from the fully charged battery.

2.   RED cable last from both batteries.