Poulan 191697 ユーザーズマニュアル

12

The tires on your tractor were overinfl ated 
at the factory for shipping purposes.  Cor-
rect tire pressure is important for best 
cutting performance.
•   Reduce tire pressure to PSI shown in 

“PRODUCT SPEC I FI CA TIONS” section 
of this manual.

For best cutting results, mower housing 
should be properly leveled.  See “TO LEV-
EL MOWER HOUSING” in the Service 
and Adjustments section of this manual.

See the fi gures that are shown for replac-
ing motion and mower blade drive belts 
in the Service and Adjustments sec tion 
of this manual.  Verify that the belts are 
routed cor rect ly.

After you learn how to operate your trac-
tor, check to see that the brake is properly 
adjusted.  See “TO ADJUST BRAKE” in 
the Service and Adjustments section of 
this manual.

✔CHECKLIST

Before you operate your new trac tor, we 
wish to as sure that you re ceive the best 
performance and sat is fac tion from this 
quality product.
Please review the following checklist:

✓  All assembly instructions have been 

com plet ed.

✓ No remaining loose parts in carton.

✓ Battery is properly prepared and 

charged.   (Minimum 1 hour at 6 amps).

✓ Seat is adjusted comfortably and tight-

 ened securely.

✓ All tires are properly infl ated.  (For ship-

 ping purposes, the tires were over in -
fl ated at the factory).

✓ Be sure mower deck is properly lev eled 

side-to-side/front-to-rear for best cutting 
results.  (Tires must be properly in fl at ed 
for leveling).

✓ Check mower and drive belts.  Be sure 

they are routed prop er ly around pul leys 
and inside all belt keepers.

✓ Check wiring.  See that all connections 

are still secure and wires are properly 
clamped.

✓ Before driving tractor, be sure free wheel 

control is in “transmission engaged” 
position (see “TO TRANS PORT” in the 
Operation section of this man u al).

While learning how to use your tractor, pay 
extra attention to the following im por tant 
items:

✓ Engine oil is at proper level.

✓ Fuel tank is fi lled with fresh, clean, reg-

 u lar unleaded gas o line.

✓ Become familiar with all controls - their 

location and func tion.  Operate them 
be fore you start the engine.

✓ Be sure brake system is in safe op er -

at ing condition.

✓ It is important to purge the trans mis sion 

before op er at ing your tractor for the fi rst 
time.  Follow proper starting and trans-
 mis sion purg ing instructions (See “TO 
START EN GINE” and “PURGE TRANS-
 MIS SION” in the Op er a tion sec tion of 
this man u al).