Gardena R40Li ユーザーズマニュアル

32 - English 

Before the robotic lawnmower is operated, a start-up 
sequence in the robotic lawnmower's menu must be 
carried out as well as an automatic calibration of the 
guide signal. The calibration is also a good test to see 
that the installation of the guide wire has been done in 
such a way that the robotic lawnmower can easily 
follow the guide wire from the charging station.

1.

Set the main switch to position 1.

2.

Open the control panel cover by pressing the 
STOP button.

A start-up sequence begins when the robotic 
lawnmower is started for the first time. The 
following is requested:

• Language

• Time format

• Current time

• Date format

• Date

• Four digit PIN code. All combinations except 

0000 are permitted.

3.

Place the robotic lawnmower in the charging 
station as requested in the display. Press the 
START button and close the cover. The robotic 
lawnmower will now start the guide calibration, by 
leaving the charging station and following the 
guide wire to the point where the guide wire is 
connected to the boundary wire to begin mowing 
there. Check that the robotic lawnmower can 
follow the guide wire all the way. 

If it cannot, this may be due to an incorrectly 
installed guide wire. In this case, check that the 
installation is performed as described in 
3.6 Installation of the guide wire on page 28. Then 
carry out a new calibration. See 6.6 Settings on 
page 51.

In the case of the R70Li, it is also possible to 
reduce the guide width for the robotic lawnmower 
to follow the guide wire through very narrow 
passages. See 6.4 Installation, R70Li on page 45. 
Use the Test out function to carry out a new 
calibration in the R70Li. See 6.4 Installation, R70Li 
on page 45.

Use Memo on page 4 to make a note of the 
PIN code.