Gardena R70Li ユーザーズマニュアル

 

English - 15

 

This chapter describes how you install the GARDENA 
robotic lawnmower. Before starting the installation 
read the previous chapter 

 

.

Read also through this entire chapter before beginning 
the installation. How the installation is done also 
affects how well the robotic lawnmower works. It is 
therefore important to plan the installation carefully.

Planning is simplified if you make a sketch of the 
working area, including all obstacles. This makes it 
easier to see the ideal positions for the charging 
station, the boundary wire and the guide wire. Draw on 
the sketch where the boundary and guide wires should 
be routed.

See 

 

 on page 54 for installation 

examples.

Visit also www.gardena.com for further descriptions 
and tips regarding installation. 

 

3.1 Preparations.

3.2 Installation of the charging station.

3.3 Charging the battery.

3.4 Installation of the boundary wire.

3.5 Connecting the boundary wire.

3.6 Installation of the guide wire

3.7 Checking the loop.

3.8 First start-up and calibration

3.9 Test docking with the charging station

The charging station and boundary and guide wires 
must be connected to be able to carry out a complete 
start-up of the robotic lawnmower. 

 

1.

If the lawn in the working area is longer than 
10 cm, mow it using a standard lawnmower. 
Then collect the grass.

2.

Read carefully through all the steps before the 
installation.

3.

Check that all parts for the installation are 
included. The numbers in brackets refer to the 
component illustration 

 

.

• Operator's Manual (25)

• Robotic lawnmower

• Charging station (6)

• Loop wire for boundary wire and guide wire (16)