Gardena R70Li ユーザーズマニュアル

English - 33

Before using the robotic lawnmower, check that the 
robotic lawnmower can follow the guide wire all the 
way to the charging station and easily docks with the 
charging station. Perform the test below. 

1.

Open the control panel cover by pressing the 
STOP button.

2.

Place the robotic lawnmower close to the point 
where the guide wire is connected to the boundary 
wire. Place the robotic lawnmower about 2 metres 
from the guide wire, facing the guide wire.

3.

Select Home mode by pressing the house symbol 
key and pressing OK when the cursor is at Home. 
Press Start and close the cover.

4.

Check that the robotic lawnmower follows the 
guide wire all the way to the charging station and 
that it docks with the charging station. The test is 
approved only if the robotic lawnmower is able to 
follow the guide wire the entire distance to the 
charging station and docks at the first attempt. If 
the robotic lawnmower is unable to dock on the 
first attempt, it will automatically try again. The 
installation is not approved if the robotic 
lawnmower needs two or more attempts to dock 
with the charging station. In this case, check that 
the charging station, the boundary wire and the 
guide wire are installed in accordance with the 
instructions in Chapters 3.2, 3.4 and 3.6.

5.

The robotic lawnmower will stay in the charging 
station until Auto or Man mode is selected. See 
5.1 Operation selection on page 39. 

The guide system must first be calibrated if the above 
test is to provide a satisfactory result. See 3.8 First 
start-up and calibration on page 32.