Husqvarna RZ54i / 967003604 ユーザーズマニュアル

26

OPERATION

NOTES: The default passcode [321] is preset at the 
factory. For safety and security, the passcode should 
be changed prior to use.
Resetting ignition system passcode
1.  To initialize the ignition system, press the START/

STOP (S/S) button on the ignition switch or sit on 
the seat. The blue indicator will blink, showing the 
system is operational.

2.  Using the lower buttons, press and hold the 

(1) and (3) buttons at the same time for three 
seconds. The blue indicator will then be lit 
continuously, signalling the system is ready to 
accept a new code.

3.  Using the lower buttons, enter a desired code of 

numbers from one to five digits and then press the 
S/S button. The indicator will blink green to signal 
the passcode has been accepted.

4.  If the S/S button blinks red, the passcode reset 

has not been accepted. Wait for the S/S button to 
return to blinking blue and retry the programming, 
starting at Step 1.

8058-235

1.  Start/Stop Button
2.  Numbered buttons
Press buttons to enter new passcode

8058-236