Husqvarna RZ54i / 967003604 ユーザーズマニュアル

43

MAINTENANCE

Check every 100 hours of operation. Check for severe 
cracking and large nicks.
NOTE: The belt will show some small cracks in normal 
operation.
The belts are not adjustable. Replace belts if they 
begin to slip from wear.

Deck Belt Removal
1.  Park on a level surface. Apply parking brake.
2.  Lower the deck into the lowest cutting position.
3.  Remove bolts from belt shields and remove 

shields.

4.  Remove any dirt or grass that may have 

accumulated around the cutter housings and 
entire deck surface.

5.  Loosen the nut securing the belt guide. Note the 

position of the belt guide for reinstallation.

6.  Push inward on the idler arm to release the 

tension on the belt. 

7.  Carefully slip the belt over the top of the cutter 

housing pulleys and remove belt from the deck.

1.  Wrap the deck belt around the electric clutch 

pulley that is located on the engine shaft.

2.  Route the belt forward and up onto the deck.
3.  Place belt around spring loaded idler pulley.
4.  Wrap the belt around the stationary idler pulley 

and around the mandrel housings.

5.  Push inward on the idler arm and carefully route 

belt over stationary idler pulley. Once the belt is 
properly routed, slowly release the idler arm to 
tension belt.

6.  Double check belt routing to make sure it 

matches the decal affixed to the deck, and the 

belt does not have any twist. Correct if needed.

7.  Tighten the belt guide and replace belt shields on 

both mandrel housings and secure with fasteners. 
NOTE: The belt guide should be perpendicular to 
the belt when installation is complete.

8058-197

1.  Belt guide
2.  Idler arm
Removing the deck belt

8050-143