Husqvarna TS300-E3 ユーザーズマニュアル

03125

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.
When right or left hand is mentioned in this man ual, it means 

when you are in the operating po si tion (seated be hind the 

steer ing wheel).

•  Cut along dashed lines on all four panels of carton. 

Remove end panels and lay side panels flat.

•  Check for any additional loose parts or cartons and 

remove.

•  Lift seat pan to raised position and open battery box 

door.

•  If this battery is put into service after month and year 

indicated on label (label located between terminals) 

charge battery for minimum of one hour at 6-10 amps. 

(See "BATTERY" in Maintenance  section of this manual 

for charging in struc tions).

•  Slide extension shaft onto lower steering shaft.  
•  Place tabs of steering boot over tab slots in dash and 

push down to secure.

• 

Position front wheels of the tractor so they are pointing 

straight forward.

•  Remove steering wheel adapter from steering wheel 

and slide adapter onto steer ing shaft ex ten sion.

•  Position steering wheel so cross bars are hor i zon tal 

(left to right) and slide inside boot and onto adapt er.

• 

Assemble large flat washer, 5/16 lock washer, 5/16 hex 

bolt and tighten se cure ly.

•  Snap steering wheel insert into center of steer ing 

wheel.

•  Remove protective materials from trac tor hood and 

grill.

IMPORTANT:  CHECK FOR AND REMOVE ANY STAPLES IN 

SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO 

ROLL OFF SKID.

02604

02602