Husqvarna 966553901 ユーザーズマニュアル

MAINTENANCE

44

8065-040

Deck Belt Removal
Park on a level surface. Apply park brake. Lower the 
deck into the lowest cutting position.
1.  Remove foot plate and belt shields.
2.  Remove any dirt or grass that may have 

accumulated around the cutter housings and 
entire deck surface.

3.  With a ½" breaker bar and using the square 

opening in the idler arm, shift the arm counter 
clockwise to relieve the tension on the belt.

4.  Carefully roll the belt over the top of the cutter 

housing pulleys.

5.  Remove the belt guide hardware with a ½" wrench 

and set belt guide aside.

6.  Remove the belt from around the electric clutch 

on the engine shaft.

8065-046

Deck Belt Installation
NOTE: For ease in installing the deck belt, refer to the 
routing decal on the cutting deck.
1.  Place the belt around all the pulleys except the 

center spindle pulley.

2.  With a ½" breaker bar, shift the idler arm counter  

clockwise. When there is enough slack, slip the 
belt onto the center spindle pulley.

3.  Reinstall the belt guide removed in Step 5 above.
4.  Double check belt routing to make sure it matches 

the routing decal, and that the belt does not have 
any twist. Correct if needed.

8065-047