Husqvarna 966553901 ユーザーズマニュアル

MAINTENANCE

47

Leveling Deck
Adjust the deck while the mower is on a level 
surface. Make sure the tires are inflated to the correct 
pressure. See Tire Pressures in Maintenance section. 

If tires are under or over inflated, the deck cannot be 
properly adjusted. Faulty mower deck adjustments will 
cause an uneven mowing result.
Four bolts control the height and pitch of the mower 
deck. The deck should be adjusted slightly higher in 
the rear.
NOTE: To insure accuracy of leveling procedure, 
mower deck drive belt must be installed prior to 
leveling the deck.
1.  Wear heavy gloves. Turn each outer blade tip to 

align the deck in a side-to-side manner.

2.  Measure from the floor surface up to the bottom 

of the blade tip on the discharge side of the 
mower deck. Retain this measurement. Move to 
the opposite side; check that measurement is 
the same. If adjustment is required, loosen the 
locknut and adjust bolt up until both side-to-side 
measurements are equal. Retain measurement.

3.  Turn both outer blades to align with the deck in 

front-to-rear manner. Reposition rear mounting 
bolts up or down until rear blade tips are 
positioned 

1

/

8

" to 

3

/

8

" higher in the rear than the 

front blade tips.

4.  Confirm measurements once again. Blade tip 

height should be equal in a side-to-side manner. 
In the rear, blade tips should be 

1

/

8

" to 

3

/

8

" higher 

than the front measurement. In the front, blade 
tips should be equal from side-to-side.

NOTE: This will place the mower deck in a standard 
measurement position. Additional adjustment may be 
required to achieve desired cut for the type of grass 
being mowed or conditions.

8065-037

1. Adjustment bolt
2. Locknut
Leveling the mower deck

8065-102