Husqvarna 230 ACX ユーザーズマニュアル

24 - English

If the working area borders against a flat path or the 
like that lies level with the lawn, it is possible to allow 
Automower to run a little over the path. The boundary 
wire should then be laid 10 cm from the edge of the 
path.

When the working area is divided by a flat slab path 
that is level with the lawn, it is possible to allow 
Automower to run over the path. It can be an 
advantage to lay the boundary wire under the slabs. 
The boundary wire can also be laid in the joint 
between the slabs.

Note! 

Automower must never run over a gravel path 

or similar material, which can damage the blades.

If the working area borders against, for example, 
pools of water the boundary wire should be 
supplemented with a fence or the like. The height must 
then be at least 15 cm. This will prevent Automower, 
under any circumstances, coming outside of the 
working area.

When Automower searches for the charging station or 
follows the loop according to the function Follow loop 
(3-2) (see page 51), it runs along the side of the 
boundary wire at a specific distance. The Corridor 
width (3-2-3) function determines the distance from the 
boundary wire that the mower shall run. It is 
recommended to state as high a Corridor width value 
as possible. A high Corridor width value reduces the 
risk of tracks forming. For more information about 
Corridor width (3-2-3), see page 54.

In exceptional cases Automower can be set to 
straddle the boundary wire, that is to say, half the 
mower inside the loop and the other half outside. The 
boundary wire must then be kept at a distance of 
about 40 cm from all the boundaries of the working 
area and from the edges of a passage.

3012-383

3012-534

 3012-459