Husqvarna 230 ACX ユーザーズマニュアル

36 - English

If you shall install the guide wire through a passage:

•

Automower follows the guide wire on the same 
side of the wire both to and from the charging 
station. This means that in towards the charging 
station the guide wire is on the right side of the 
mower and away from the charging station the 
guide wire is on the left side of the mower.

In the passage, the guide wire must be placed so 
that the mower has as much space to run as 
possible. The distance between the boundary 
wire and the guide wire must however be at least 
30 cm (see the picture above).

The same minimum distance (30 cm) also 
applies between the guide wire and the guide 
wire in the passage,

Avoid laying the wire at sharp angles. This can make 
it difficult for the mower to follow the guide wire.

6.

Run the guide wire to the spot on the boundary 
wire where you want to make the connection.

7.

Lift out the boundary wire.

8.

Cut off the boundary wire using a pair of wire 
cutters.

9.

Connect the guide wire to the boundary wire with 
the help of a solderless coupler: 

• Insert the ends of the boundary wire in the right 

respective left-hand holes on the connector.

• Insert the end of the guide wire in the centre 

hole.

• Press down the button on the connector fully.

10. Staple down/bury the connector in the lawn.

The function of the guide wire varies 
depending on how the working area appears. 
It is therefore recommended to test the 
installation with the help of the function Test 
IN (3-2-4), see page 55.

 3012-649

135º

135º

90º

 3012-742

 3012-675