Husqvarna 305 プリント

ページ / 2
HUSQVARNA AUTOMOWER
®
305/308 
QUICK GUIDE
www.automower.com
115 49 22-26
ADJUSTING THE ROBOTIC LAWNMOWER TO SUIT  
THE SIZE OF YOUR LAWN
The mowing results depend on mowing time. Adjust the 
mowing time to suit your garden using the Timer function.
If the robotic lawnmower cuts too often: The lawn will look 
trampled.
If the robotic lawnmower cuts too seldom: The lawn will not 
be properly mown.
TIMER
ADJUSTING THE ROBOTIC LAWNMOWER FOR 
NARROW PASSAGES
Narrow passages in the garden make it difficult for the 
robotic lawnmower to find the charging station. Use the 
Test OUT function to test if the robotic lawnmower is able 
to pass through the narrowest passages.
1.  Place the robotic lawnmower in the charging station.
2.  Select Test OUT (Installation - Test OUT) in the robotic 
lawnmower’s menu and press OK. Then press the Start 
button and close the cover.
3.  Check that the robotic lawnmower follows the guide wire 
through the passage.
 
a.  If the robotic lawnmower gets through the passage: 
The test is complete!
 
b.  If the robotic lawnmower does not get through the 
passage: Change the Guide width from Wide to 
Medium. If required, the guide width can also be 
changed from Medium to Narrow.
ADJUSTING THE ROBOTIC LAWNMOWER TO SUIT YOUR GARDEN
See chapters 6.3 and 6.4 in the Operator’s Manual.
Here you will find some tips on important settings for your robotic lawnmower.
All settings for your robotic lawnmower are made via the menu functions.
You decide what times during the day the robotic lawnmower 
is to work. The robotic lawnmower mows about 45 m² per 
hour and day (approx. 30 m² for the Automower
®
 305). For 
example; if your garden consists of 360 m² of grass, the robotic 
lawnmower should work on average 8 hours per day (12 hours 
for the Automower
®
 305).
AUTOMOWER
®
 is a trademark owned by Husqvarna AB. Copyright © 2013
 
HUSQVARNA. All rights reserved.
STARTING AND STOPPING
See chapters 4.3 and 4.4 in the Operator’s Manual. 
STARTING
1.  Open the cover by pressing the STOP button.
2.  Set the main switch to position 1. When you do this for 
the first time, a start up sequence starts where you select a 
four digit PIN code among other things. 
3.  Press the START button.
4.  Close the cover.
STOPPING
Press the STOP button.
1
3
6
5
3