Husqvarna EZ4824 CA/ 966659501 ユーザーズマニュアル

MAINTENANCE

41

Leveling deck
Adjust the deck while the mower is on a level 
surface. Make sure the tires are inflated to the correct 
pressure. See Technical Data under Transmission. 

If tires are under or over inflated, the deck cannot be 
properly adjusted.
The deck should be adjusted slightly higher in the 
rear.
NOTE: To insure accuracy of leveling procedure, 
mower deck drive belt must be installed prior to 
leveling deck.
1.  Wear heavy gloves. Turn each outer blade tip to 

align front to rear with the deck (1) or side-to-side 
(2).

2.  Measure from the floor surface up to the bottom of 

the blade tip on the discharge side of the mower 
deck. Record the measurement.

3.  Move to the opposite side, check that 

measurement is the same. If adjustment is 
required—with a ¾" or adjustable wrench, turn 
the lift link adjustment nuts on either side counter 
clockwise to lower or clockwise to raise. Adjust 
until both measurements are equal.

8058-030

8058-031

4.  Turn any blade to align with the deck in front-

to-rear manner. If the front blade tip does not 
measure 

1

/

8

" to ½" higher in the rear—with a 

5

/

8

 

or adjustable wrench, turn the nuts on the front 
suspension linkage. Clockwise raises the front of 
the mower, counterclockwise will lower the front. 
Adjust nuts until rear of mower deck is positioned 
level to 

1

/

8

" higher in the rear than the side-to-side 

measurement.
NOTE: This will place the mower deck in a 
standard measurement position. Depending on 
the type of grass being mowed or environmental 
conditions, additional adjustments may be 
required to achieve the desired cut.

8058-030