Husqvarna 968999766 ユーザーズマニュアル

English

-

60

7.  Drain old oil filters of all free flowing oil prior to 

disposal. Place used oil in appropriate containers 

and dispose of it in accordance with laws in your 

area.

8.  Remove the top port plug (see illustration) from 

the left side and right side of the transaxles prior to 

filling with oil. This will allow the transaxles to vent 

during oil fill.

9.  Remove the cap from the transaxles’ expansion 

tank located on the vehicle frame.

10. Fill with 20W50 motor oil until oil just appears 

at the bottom of each transaxles’ top port 

(approximately 2 quarts per transaxle, 4 quarts 

total). Install the top port lug into each transaxle as 

the oil level reaches this port.

11. Install and torque the top port plugs to 180 in./lbs.
12. Continue to fill the transaxles through the 

expansion tank until the “Full Cold” line is reached 

(this will take approximately 23 additional ounces).

13. Re-install the expansion tank cap by hand. Be 

careful to not overtighten.

14. Proceed to the purge procedure.

1. Filter
2. Top Port Plug
3. Filter Guard
4. Screws

8019-019

1

3

4

2

1

3

2

1. Expansion Tank
2. Cap
3. Transaxles

8019-012-1