Husqvarna YTH2754T ユーザーズマニュアル

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  

To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 

the correct tools as necessary to insure proper tightness.

•  Remove all accessible loose parts and parts cartons  

from carton .

•  Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels flat.

•  Remove mower and packing materials.
•  Check for any additional loose parts or cartons and 

remove.

•  Lift hood to raised position.
NOTE: If this battery is put into service after month and 

year indicated on label (label is located between terminals) 

charge battery for minimum of one hour at 6-10 amps. 

(See "BATTERY" in Maintenance  section of this manual 

for charging instructions).
•  For battery and battery cable installation see "RE-

PLACING BATTERY" in the "Service and Adjustments" 

section in this manual.

A socket wrench set will make assembly easier.  Stan dard 

wrench sizes are listed.
(2)  7/16" wrenches 

 

Utility knife

(1)  1/2" wrench  

 

Tire pressure gauge

(1) 

3/4" 

wrench 

  Pliers

(1)  3/4" socket w/drive ratchet 

When right or left hand is mentioned in this man ual, it means 

when you are in the operating po si tion (seated be hind the 

steer ing wheel).

•  Sit in seat.
• 

Lift up adjustment lever (A) and slide seat until a com-

fortable position is reached which allows you to press 

clutch/brake pedal all the way down.

•  Release lever to lock seat in position.

NOTE: You may now roll your tractor off the skid. Follow the 

instructions below to remove the tractor from the skid.

  WARNING: Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 

sure tractor is in a well-ventilated area. Be sure the area in  

front of tractor is clear of other peo ple and objects.

•  Raise attachment lift lever to its highest po si tion.
• 

Release parking brake by de press ing clutch/brake ped al.

•  Place freewheel control in "trans mis sion dis en gaged" 

position (See “TO TRANS PORT” in the Op er a tion 

section of this manual).

•  Roll tractor forward off skid.
Continue with the instructions that follow.