Husqvarna YTH2248 ユーザーズマニュアル

•     For ease of mower to tractor assembly, raise gauge 

wheels to highest position and retain with clevis pins 
and spring retainers.

•         Adjust gauge wheels before operating mower. See “TO 

ADJUST GAUGE WHEELS” in the Operation sec tion 
of this manual.

0278

0

Be sure tractor is on level surface and mower suspension 
arms are raised with attachment lift control. Engage park-
 ing brake.
 •     Cut and remove ties securing anti-sway bar and belts.  

Swing anti-sway bar to left side of mower deck.

 •     Slide mower under tractor with defl ector shield to right 

side of tractor.

IMPORTANT:  Check belt for proper routing in all mower 
pulley grooves. 
 •    If equipped, turn height ad 

just ment knob coun 

ter -

clock wise until it stops.

 •     Lower mower linkage with attachment lift control.
 •     Install belt into electric clutch pulley groove.
 •     Place the suspension arms on outward pointing deck 

pins.  Retain with double loop re tain er spring with loops 
up as shown.

 •    Install front plate assembly to tractor suspension 

brack ets and retain with single loop retainer springs 
as shown.

 •    Position front plate assembly between front mower 

brack ets. Raise deck and plate assembly to align holes 
and insert fl anged pins. Secure pins with double loop 
retainer springs between the plate and mower brack-
ets.

NOTE: To assist in locating hole in fl anged pin, the hole in 
pin is inline with notch on head of pin. If necessary, move 
mower side-to-side to give space between plate and mower 
brackets.

IMPORTANT:  Check belt for proper routing in all mower 
pulley grooves. 
 •    Connect anti-sway bar to chassis bracket under left 

foot rest and retain with double loop retainer spring.

 •     If equipped, turn height adjustment knob clock wise to 

remove slack from mower sus pen sion.

 •     Raise deck to highest position.
 •     Adjust gauge wheels before op er at ing mower as shown 

in the Operation section of this manual.