Husqvarna PZ5430 ユーザーズマニュアル

CONTROLS

23

The cutting height pedals release the deck lift to allow 
setting the desired deck height. Apply pressure to the 
lift pedal and rotate foot to also apply pressure to the 
release pedal, unlocking the deck lift.
For transport, push the lift pedal fully forward until the 
deck lift latches in the transport (highest) position.

8065-017

1. Lift pedal
2. Release pedal
Cut height selection pedals

If the mower is not tracking straight, check the 
air pressure in both rear tires. Recommended air 
pressure for the rear tires is 15 psi (1 bar).
1.  Tracking adjustments are made using the tracking 

bolt and tracking knob. The tracking bolt and 
tracking knob act as limiting devices for the 
motion control levers when in the full-forward 
position.

2.  For preliminary tracking adjustment, move unit 

to an open, unobstructed area such as an empty 
parking lot or open field.

3.  Back the tracking bolt out until flush with nut.
4.  Loosen tracking knob out until flush with nut.
5.  Test operate unit by driving it at full throttle and 

the full forward position on both motion control 
levers. Gradually turn in the tracking bolt on the 
right hand side until the unit noticeably starts 
drifting right.

6.  Drive forward at full throttle with both motion 

control levers in the full forward position. 
Gradually turn in the tracking knob (left side) until 
unit tracks straight.

8065-060