Husqvarna 6521CM ユーザーズマニュアル

ページ / 18
4
ASSEMBLY
Read these instructions and this man u al in its entirety before you attempt to assemble or operate your new lawn mow er. 
IMPORTANT:  THIS LAWN MOWER IS SHIPPED WITH OUT OIL OR GASOLINE IN THE ENGINE.
Your new lawn mower has been as sem bled at the factory with the ex cep tion of those parts left unassembled for shipping 
purposes. All parts such as nuts, washers, bolts, etc., necessary to com plete the as sem bly have been placed in the parts 
bag. To ensure safe and proper operation of your lawn mow er, all parts and hard ware you assemble must be tightened 
se cure ly. Use the correct tools as nec es sary to ensure proper tightness.
TO ASSEMBLE GRASS CATCHER
(See Fig. 2)
1.    Put grass catcher frame into grass bag with rigid part 
of bag on the bottom. Make sure the frame handle is 
outside of the bag top.
2.    Slip vinyl bindings over frame.
NOTE:  If vinyl bindings are too stiff, hold them in warm water 
for a few minutes. If bag gets wet, let it dry before using.
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a 
mulcher.  To convert mower to bagging or discharging, 
see “TO CON VERT MOWER” in the Operation section of 
this man u al.
FIG. 1
OPERATOR 
PRESENCE
CONTROL 
BAR
HANDLE 
KNOB
LIFT 
UP
LIFT 
UP
LOWER 
HANDLE
MOWING 
PO SI TION
UPPER 
HANDLE
FIG. 2
FRAME 
HANDLE
VINYL
BINDINGS
FRAME 
OPENING
TO RE MOVE LAWN MOW ER FROM CAR TON
1.    Remove loose parts included with mower.
2.    Cut down two end corners of  car ton and lay end panel 
down fl at.
3.      Remove all packing materials ex cept padding be tween 
upper and lower handle and padding holding operator 
presence control bar to up per handle.
4.    Roll lawn mower out of carton and check carton thor-
ougly for ad di tion al loose parts.
HOW TO SET UP YOUR LAWN MOW ER 
TO UNFOLD HANDLE (See Fig. 1)
IMPORTANT:  UNFOLD HANDLE CAREFULLY SO AS 
NOT TO PINCH OR DAMAGE CON TROL CABLES. 
1.   Raise handles until lower handle section locks into 
place in mowing position.
2.    Remove protective padding, raise upper handle sec-
 tion into place on lower handle and tighten both handle 
knobs.
3.    Remove  handle  padding  holding  operator  pres ence 
control bar to upper handle.
Your handles may be adjusted for your mowing comfort. 
Refer to “ADJUST HANDLE” in the Service and Ad just ments 
sec tion of this man u al.