Husqvarna PZ29D BF ユーザーズマニュアル
1
2
MaINTeNaNCe
46
Pump Belt
The pump belt is not adjustable. Replace the belt if it
begins to slip from wear.
begins to slip from wear.
Replacing Pump Belt
Park the mower on a level surface. Engage the
parking brake and disconnect negative cable from
battery. Jack or hoist the rear of the unit off of the
ground to access the bottom of the unit.
Park the mower on a level surface. Engage the
parking brake and disconnect negative cable from
battery. Jack or hoist the rear of the unit off of the
ground to access the bottom of the unit.
Belt Removal/Installation
Remove the skid plate and the left drive tire.
1.
With a ½" breaker bar and using the square
2.
opening in the idler arm, shift the arm counter
clockwise to create slack in the belt.
Remove belt from the engine and pump pulleys.
clockwise to create slack in the belt.
Remove belt from the engine and pump pulleys.
3.
To reinstall, reverse the above procedure using
4.
the belt routing diagram located on the left rear
side of the hydraulic reservoir.
side of the hydraulic reservoir.
8065-077
Belt routing decal
1.
Idler release placement
2.
Pump belt removal
Pump belt removal
Double check belt routing to make sure it
4.
matches the routing decal, and that the belt
does not have any twist. Correct if needed.
Adjust belt tension by turning the eyebolt until
does not have any twist. Correct if needed.
Adjust belt tension by turning the eyebolt until
5.
there is approximately
7
/
8
" -1" of threads showing
outside the nut.
Belt tension should be set to 60-70 lbs.
Belt tension should be set to 60-70 lbs.
6.
Replace belt shields on both mandrel housings
7.
and secure with fasteners.
8065-054
Adjust belt tension