Husqvarna 67521 ES ユーザーズマニュアル

Read these instructions and this man ual in its entirety before you attempt to assemble or operate your new lawn mow er. 

IMPORTANT:  THIS LAWN MOWER IS SHIPPED WITH OUT OIL OR GASOLINE IN THE ENGINE.

Your new lawn mower has been as sembled at the factory with the ex ception of those parts left unassembled for shipping 
purposes. All parts such as nuts, washers, bolts, etc., necessary to com plete the as sembly have been placed in the parts 
bag. To ensure safe and proper operation of your lawn mow er, all parts and hard ware you assemble must be tightened 
securely. Use the correct tools as nec essary to ensure proper tightness.

1.  Put grass catcher frame into grass bag with rigid part 

of bag on the bottom. Make sure the frame handle is 
outside of the bag top.

2.  Slip vinyl bindings over frame.

NOTE:  If vinyl bindings are too stiff, hold them in warm water 
for a few minutes. If bag gets wet, let it dry before using.

Your lawn mower was shipped ready to be used as a 
mulcher.  To convert mower to bagging or discharging, 
see “TO CON VERT MOWER” in the Operation section of 
this man ual.

NOTE:  Your battery must be charged before you can start 
your lawn mower.

1. Con 

nect battery charger con nector (male) to harness 

connector (fe male).

2.  Plug battery charger into 110 volt A.C. outlet.

3.  Leave battery charger connected for 24 hours before 

starting your engine for the first time.

4.  After charging, disconnect harness connector (female) 

from bat tery charger connector (male).

Connect your battery charger to charge battery after each use.

IMPORTANT: THE ENGINE WILL NOT RECHARGE YOUR 
BATTERY.  AT THE END OF THE MOWING SEASON THE 
BATTERY SHOULD BE CHARGED FOR 48 HOURS TO 
PROTECT THE BATTERY DURING WINTER STORAGE.

LIFT 
UP

LIFT 

UP

MOWING

POSITION

1.  Remove loose parts included with mower.

2.  Cut down two end corners of  car ton and lay end panel 

down flat.

3.  Remove all packing materials ex cept padding be tween

upper and lower handle and padding holding operator 
presence control bar to up per handle.

4.  Roll lawn mower out of carton and check carton thor-

ougly for ad ditional loose parts.

IMPORTANT:  UNFOLD HANDLE CAREFULLY SO AS 
NOT TO PINCH OR DAMAGE CON TROL CABLES. 

1.  Raise handles until lower handle section locks into 

place in mowing position.

2.  Remove protective padding, raise upper handle sec tion

into place on lower handle and tighten both handle knobs.

3.  Remove handle padding holding operator pres ence

control bar to upper handle.

Your handles may be adjusted for your mowing comfort. 
Refer to “ADJUST HANDLE” in the Service and Ad justments 
section of this man ual.