Husqvarna Robotic Lawn Mowe ユーザーズマニュアル

34

Automower from

™

1.

Open the control panel cover by pressing the 
STOP button.

2.

Place the Automower in the charging station.

3.

Set the main switch to the ON position.

A start-up sequence begins when the Automower 
is started for the first time. The following is 
requested: Language, time format, correct time, 
date format, date, and four-digit PIN code. All 
combinations except 0000 are permitted.

When you have chosen a PIN code with the 
Automower placed in the charging station, the mower 
and charging station are then linked to each other.

The guide wire is an extra wire that is laid from the 
charging station, out towards a remote part of the 
working area or through a narrow passage and is then 
connected to the boundary wire. The same wire used 
for the boundary wire is also used for the guide wire.

In similarity to the boundary wire, the guide wire can 
either be stapled down or buried.

When a guide wire is installed, the Automower can also 
be set to follow the guide wire out from the charging 
station using the function Follow loop out (3-2-1), see 
page 53.

The guide wire may be necessary in installations 
where the search methods Irregular and Follow loop in 
are not adequate for the mower to quickly and easily 
find the charging station.

A few examples of installations where a guide wire is 
recommended follow below:

•

Narrow passages.

In passages where the distance between the 
boundary wires is less than 3 metres, it is 
recommended to install a guide wire through the 
passage. This is a better solution than allowing 
Automower to follow close to the boundary wire by 
setting a low Corridor width value.

3012-385 
3012-408