Husqvarna LT1536 ユーザーズマニュアル

✓

BEFORE YOU OPERATE AND ENJOY YOUR NEW  TRAC-
 TOR, WE WISH TO ASSURE THAT YOU RE CEIVE THE 
BEST PER FORM ANCE AND SATISFACTION FROM THIS 
QUAL ITY PRODUCT.

PLEASE REVIEW THE FOLLOWING CHECKLIST:
✓    All assembly instructions have been completed.

✓    No remaining loose parts in carton.

✓    Battery is properly prepared and charged.   (Minimum 

1 hour at 6 amps).

✓    Seat is adjusted comfortably and tightened securely.

✓    All tires are properly infl ated.  (For shipping purposes, 

the tires were overinfl ated at the factory).

✓   Be sure mower deck is properly leveled side-to-side/

front-to-rear for best cutting results.  (Tires must be 
properly infl ated for leveling).

✓     Check mower and drive belts.  Be sure they are routed 

properly around pulleys and inside all belt keepers.

✓    Check wiring.  See that all connections are still secure 

and wires are properly clamped.

WHILE LEARNING HOW TO USE YOUR TRAC TOR, PAY 
EXTRA ATTENTION TO THE FOLLOWING IM POR TANT 
ITEMS: 
✓   Engine oil is at proper level.

✓   Fuel tank is fi lled with fresh, clean, regular unleaded 

gas o line.

✓   Become familiar with all controls - their location and 

function.  Operate them before you start the engine.

✓    Be sure brake system is in safe operating condition.

The tires on your tractor were overinfl ated at the factory 
for shipping purposes.  Correct tire pressure is important 
for best cutting performance.
•     Reduce tire pressure to PSI shown in “PRODUCT 

SPEC I FI CA TIONS” section of this manual.

For best cutting results, mower housing should be properly 
leveled.  See “TO LEVEL MOWER HOUSING” in the Service 
and Adjustments section of this manual.

See the fi gures that are shown for replacing motion and 
mower blade drive belts in the Service and Adjustments 
sec tion of this manual.  Verify that the belts are routed 
correctly.

After you learn how to operate your tractor, check to see that 
the brake is properly adjusted.  See “TO ADJUST BRAKE” 
in the Service and Adjustments section of this manual.

WARNING: Before starting, read, un der stand and follow 

all in struc tions in the Operation section of this manual. Be 
sure tractor is in a well-ventilated area. Be sure the area in  
front of tractor is clear of other people and objects.
•      Be sure all the above assembly steps have been com-

pleted.

•      Check engine oil level and fi ll fuel tank with gasoline.
•      Sit on seat in operating position, depress clutch/brake 

pedal and set the parking brake.

•      Place gear shift lever in neutral (N) position.
•      Press lift lever plunger and raise attachment lift lever 

to its highest position.

•        Start the engine. After engine has started, move throttle 

control to idle position.

•      Depress clutch/brake pedal into full "BRAKE" position 

and hold. Move gearshift lever to 1st gear.

•    Slowly release clutch/brake pedal and slowly drive 

tractor off skid.

•        Apply brake to stop tractor, set parking brake and place 

gearshift lever in neutral position.

•      Turn ignition key to "OFF" position.
Continue with the instructions that follow.